четверг, 26 сентября 2019 г.

Robot 2020.1

Robot получил небольшое обновление:

This release updates the Australian steel design codes to the current edition AS 4100-1998 Rec.2016.

General
  • Improved the general user interface behavior on high resolution monitors. Dialog layouts, tables contents, graphics have been affected when the size of text and application were scaled.
  • Removed “Unregistered version” displayed on the program title bar reported for single-user license installations.
  • Corrected the display of load values for American (imperial) units in the moving load vehicle definition.

Reinforced Concrete Design
  • Prevents the shift of slab reinforcement manual zones after an element update.
  • Corrected the influence of Cm parameter on slenderness and strength calculation for reinforced columns according to ACI 318-14.
  • Corrected column slenderness limits according to ACI 318-14.
  • Corrected the calculation of crack width for slabs according to EN 1992-1-1.
  • Added Eurocode formula 9.3.1.1 (3) for minimal reinforcement calculation in cases of unidirectional reinforcement of slabs.
  • Fixed the formula for conditions without drainage for foundation slip resistance according to EN 1997.
  • Corrected the calculation of crack width for beams and columns according to EN 1992-1-1.

Steel Connection Design
  • Corrected the behavior when a Pinned Beam-to-Beam steel connection is copied and then the angle used is changed to the default.
  • Web plate stiffeners are now considered in calculations of Beam-Column connection rigidity.

Steel and Timber Design
  • Corrected the calculation of elasticity modulus in fire conditions for timber design code EN 1995-1-1.
  • Improved display of stability coefficients according to EN 1993-1-1 for round sections in bidirectional bending.

Revit-Robot Structural Analysis Link Enhancements
  • You can send grouped members on selection from Revit.
  • Boundary Conditions are updated in Revit.
  • Steel design parameters are preserved through a roundtrip.
  • Materials parameters are updated during a roundtrip.